Last updated: November 7, 2026
After a heavy summer storm in the hills, or on some of the older rural roads, you sooner or later meet a stretch of water lying across the tarmac, and sometimes a proper shallow ford where a stream crosses the track. Most riders' first instinct is to back off and wonder, and that caution is sensible, because water hides more than it shows. The surface underneath could be perfectly sound or washed away, the depth could be a few inches or up to the engine, and rushing in is how bikes get swamped and stall. I have crossed a good many of these over the years, and the approach is less about daring than about patience and a few simple habits. This is how I decide whether to go through, and how I do it.
First, stop and judge it properly
I never ride into standing water without knowing what is underneath, and if I cannot see the bottom or tell how deep it is, I get off the bike and look. Watching another vehicle go through is genuinely useful, because it gives away the depth and where the firm ground is, and if nothing is coming I will walk the line in my boots, probing with my feet for a washed-out edge, a deep rut or a hidden rock. The golden rule is simple: if the water would reach the engine's air intake, the exhaust or the electrical parts, or if the current is pushing hard, I do not ride it. Turning back or waiting is never the wrong answer, and a flooded road often drops to nothing within an hour or two.
Pick the firmest line, not the shortest
Once I am sure a crossing is safe, I choose the line carefully, and it is not always the obvious straight one. I favour where the water looks shallowest and the ground firm, often following the worn vehicle tracks, and I avoid the edges where the water may have scoured the road away. On a gentle slope I prefer to cross slightly with the flow rather than fight straight into a current, and I mark a clear exit point on the far side so I know where I am aiming before the water starts splashing up and hiding my view. A moment planning the line beats a moment of panic in the middle.
Ride slowly, steady and in the right gear
The actual crossing is done slowly and deliberately. I select a low gear before I enter, keep the engine pulling with a steady throttle so it does not bog or stall, and ride at a controlled walking pace rather than charging through. Going fast throws a wall of water up over the bike and into the air intake, and it makes the tyres skim and lose grip on the bottom, whereas a slow, steady pace lets the front wheel part the water and keeps the tyres in contact with the ground. I keep my feet up on the pegs rather than dangling them, stay relaxed on the bars, and avoid sudden changes of speed or direction halfway, because a steady line is what keeps the bike upright and moving.
What to do straight afterwards
Once I am back on dry ground I do not simply carry on as if nothing happened, because wet brakes and a soaked bike need attention. I test the brakes gently a few times while riding slowly, letting the pads dry against the discs until they bite properly again, since wet brakes are weak and spongy at first. I also give the bike a quick look for anything the water has disturbed - water in the chain, mud packed around the wheels, a damp air filter or a strange noise - and I keep an eye on it for the next few miles. If the engine cut out in the water, I do not keep trying to start it; I get it onto dry ground and check it properly rather than sucking more water in. Water in the electrics or a drowned air filter is a common breakdown after a careless crossing, and forcing the engine to turn can turn a cheap drying-out job into a costly one. I also expect the electrics to play up for a few minutes - a hesitant starter, a fogged instrument - and I let things dry before I assume anything is broken. Patience here saves both the bike and the rest of the day.
Wet roads and the bigger picture
Even where there is no standing water, prolonged rain leaves the whole surface slippery, and I treat painted markings, metal covers, leaves and smooth concrete with extra care, braking earlier and gentler and keeping the inputs smooth. I also dress for it, with waterproofs and visor treatment so I can see, and I keep the chain lubricated since wet roads wash it dry. The whole mindset is the same as for a crossing: respect the water, slow down, and never let pride talk you into something you have not checked. The road will still be there when the water has gone, and a short wait beats a long, expensive repair.
The paperwork side
As with any foreign motorcycle, entry is handled through a licensed travel agency; individuals cannot clear customs on their own. The temporary plate is valid for 3 months, and the insurance is arranged before entry at the actual cost. For the customs guarantee, with our surety in place the rider only pays 10,000 RMB into the corporate account, arriving 3 days before entry and refunded in full within 3-5 working days after the bike leaves. The vehicle inspection fee is around 200 RMB for every bike. Right-hand-drive machines are accepted at every port on the same terms as left-hand-drive with no surcharge.
If you are worried about a particular route in the wet season and want a view on what is realistic, send over the plan and I will tell you honestly how I would approach it.
On a related note, I have also written about ferry here.
Ready to plan your ride into China?
Customs declaration, temporary plate, temporary licence and guarantee - handled for you end to end. Ride across the border on arrival day and keep your energy for the road.
WeChat / WhatsApp: +86 13759155671 · Email: [email protected]
Contact Us Now